I built this from a MetalSmiths 0 Gauge 70ft Ransome & Rapier Turntable, being incorporated into an 0 Gauge Layout. Motorisation is from a geared 12v dc motor rated at 2 rpm. In this case control will be by a DCC decoder, the rest of the layout is also be DCC controlled by NCE Power Procab 5amp system. To ensure the correct polarity of the turntable track, a Tam Valley Dual Frog Juicer is used.
I have also used Stepper Motor control to power Turntables, where a method of indexing the turntable is required.
This video replaces the Youtube one.
I decided to do this because:
A) No annoying adverts
B) Smoother? Hopefully there will be fewer dropped frames.